Swanstone WB-2218 - Installation - Manual (Page 9)

To prevent breakage or distortion of the overflow assembly, do
not use oil-based caulking or plumber’s putty near the
overflow assembly. Oil-based plumber’s putty will have a
harmful effect on the plastic overflow assembly, resulting in a
leak. If a sealant is required between the overflow assembly
and the tail pipe, use a silicone sealant.
8. Install tail pipe onto the sink ring.
9. Tighten the tail pipe assembly onto the sink.
Do not overtighten the nut when installing the tail pipe. Hand-
tighten the nut and then tighten NO MORE than one-half turn.
Overtightening will break the overflow assembly and void the
warranty.
10. Connect the faucet supply lines per the manufacturer’s
instructions.
11. Connect the drain lines and p-trap per the manufacturer’s
instructions.
Note: Swanstone recommends using a licensed plumber for
the installation of all necessary plumbing.
12. Turn on the water and check for leaks. Fix any leaks
immediately.
Optional Side Splash Panel Installation
1. Sand back corner of side splash panel to allow flush fitting
to vanity top.
VI-027
VI-010
VI-011
IMPORTANT NOTICE
VI-052
VI-051
No Plumber’s
Putty in this
location
IMPORTANT NOTICE
800-325-7008 9 The Swan Corporation – Swanstone
Installation Procedure