dbx DriveRack PA2 - Manual (Page 54)

50
®
Application Guide
This section of the manual shows the various ways in which the DriveRack PA2 can be configured and provides system
diagrams and application notes for each application type. Use these diagrams and notes for reference when initially connecting
and configuring the DriveRack PA2 for your application.
Full Range Application 1 (Standard)
This application is suited for full range systems which do not require an active crossover. In this type of configuration, the PA2
will send full range signal (20 Hz - 20 kHz) through the HIGH outputs. When the PA2 is configured for this type of application
using the Setup Wizard, only the HIGH outputs will be enabled; the MID and LOW outputs will be disabled and will not pass
audio.
Application Notes:
• Make sure your mixer and amplifiers (or powered speakers) are turned off before making connections.
• Make connections as described in ‘Making Connections’ on page 8 then apply power to the system according to
the instructions described in ‘Applying Power’ on page 10.
• Run the Setup Wizard and select the MONO input option if connecting your mixer to the PA2 via a single connection, or
select the STEREO input option if connecting the mixer to the PA2 via a left/right stereo connection.
• In the Setup Wizard, select your main speakers from the list. If prompted, select the PASSIVE option for your main speaker
configuration. If your speakers are not listed in the PA2, use the DriveRack PA2 control app to check the online database to
see if your speaker tunings have been added. If you can’t find speaker tunings for your speakers, select the NOT LISTED
option from the tuning list.
120V 50/60Hz
Left Main
Powered Speaker
Right Main
Powered Speaker
To Power
Outlet
or
or
or
Windows ® or Mac ®
Computer
iOS ® or Android ®
Phone
Mixer R L/Mono
Wireless Router
iOS ® or Android ®
Tablet
LEgEND
Analog Audio Connections
Omit Connection For Mono Systems Ethernet Connection
IEC Power Cord Left Channel L
Right Channel R Wi-Fi Signal