Dexter Laundry T-80 Reversing (On-Premise) - Manual (Page 16)

16
The letter “C” represents the cool down portion of the dry cycle. The two digits represent the
amount of time remaining in the dry cycle. The two-digit time, shown on the dryer controller
display, will count down to zero.
When the time decrements to zero, the dryer controller display will flash the word “donE”
and the end of cycle tone will sound.
At that point, the wrinkle free cycle will automatically begin. This cycle will wait two
minutes, if the door is not opened or the STOP touch pad key on the dryer controller is not
pressed, and then rotate the cylinder for 10 seconds and stop. This two minutes of idle time
and 10 seconds of tumble time will repeat a total of 10 times, at which time the wrinkle free
cycle stops. The cylinder will not rotate again until a new dry cycle is started.
During the wrinkle free cycle the gas valve will not be operated and there will be no heat
applied to the load. The word “donE” will also continue to flash and do so even after the
wrinkle free cycle is finished. When the dryer loading door is opened, or the STOP touch
pad key is pressed, the word “donE” will change to the word “LOAd” on the dryer controller
display. The dryer will then be ready for another dry cycle.
During the dry cycle, either pressing the STOP touch pad key on the dryer controller or
opening the dryer loading door, will stop the dry cycle and not clear it. If you press the
STOP touch pad key on the controller and then open the dryer loading door the dry cycle will
not be cleared. However, if you open (or open and close) the dryer loading door and then
press the STOP touch pad key on the dryer controller, the present dry cycle will be cleared
and the word “LOAd” will appear on the dryer controller display.
There are two jumpers and one push button on the component side of the dryer controller
printed circuit board.
The jumper located at the lower right side of the circuit board controls whether the controller
display shows and operates in the Fahrenheit or Celsius mode. This jumper is labeled as
TEMP SELECT and has three pins. The bottom and middle pins are for Celsius and the top
and middle pins are for Fahrenheit, which is indicated by the letter C for Celsius and the
letter F for Fahrenheit.
The other jumper, located at the upper right side of the component side of the dryer controller
circuit board, is used for choosing either a reversing or non-reversing type of dryer. This
jumper is labeled as REV and NON-REV. This jumper must be in the reversing position,
which are the top and middle pins. If the jumper is in the non-reversing position, the dryer
will not reverse direction.
The push button, which is located at the lower middle side of the component side of the dryer
controller circuit board, is used to reset all five of the dry cycles to the factory default
settings. It is labeled as DEFAULT SETTINGS. Even the dry cycles that have been
modified using the permanent programming procedure will be changed back to the factory
default settings when using this push button. This push button must be pressed and held for
at least three seconds with power applied to the dryer controller circuit board.