Dexter Laundry T-80 Reversing (On-Premise) User Manual
Page 23
23
been permanently changed. If they have been changed, the steps of this procedure will be the
same, but the values that are displayed will be different. The amount of times that the dryer
controller touch pad UP or DOWN keys must be pressed and released may also be different.
If you want the change to be temporary (for only one dry cycle), go to the “TEMPORARY
REVERSING DRYER CONTROLLER PROGRAMMING” section of this manual.
PROCEDURE
1. After the load has been placed in the dryer, press and release the UP or DOWN touch pad
key on the dryer controller until the L.E.D. for dry cycle 5 is illuminated.
2. Press and release the PROG touch pad key on the dryer controller. The dryer controller
display will not change.
3. Immediately, press and release the UP arrow key on the dryer controller touch pad. The
controller display will change from “LOAd” to “Prog”. You have now entered the
permanent programming mode. The dry cycle 5 L.E.D. will remain on and the programming
L.E.D. will illuminate.
4. Press and release the SELECT/ENTER touch pad key once. The dry cycle 5 L.E.D. and
programming L.E.D. will remain on and the dry time L.E.D. will illuminate. The dryer
controller will also show the number “25”.
5. Press the UP arrow touch pad key 28 times until the dryer controller display shows the
number “53”.
6. Press and release the SELECT/ENTER touch pad key once. The dry cycle 5 L.E.D. and
programming L.E.D. will remain on and the dry time L.E.D. will switch off. The
temperature L.E.D. will illuminate and the dryer controller display will show the number
“175”.
7. Press and release the UP arrow touch pad key four times until the dryer controller display
shows the number “195”.
8. Press and release the SELECT/ENTER touch pad key. The dry cycle 5 L.E.D. and the
programming L.E.D. will remain on and the temperature L.E.D. will switch off. The cool
down L.E.D. will illuminate and the dryer controller display will show the number “2”.
9. Press and release the UP arrow touch pad key once so the dryer controller display shows the
number “3”.
10. Press and release the SELECT/ENTER touch pad key. The dry cycle 5 L.E.D. and the
programming L.E.D. will remain on and the cool down L.E.D. will switch off. The reversing
L.E.D. will illuminate and the dryer controller display will show “nrEv”.