Factory Direct Hardware Hansgrohe 10456 Axor Starck - Manual (Page 3)

3
Installation Instructions
•
Turn off the water at the main.
•
Cut the plaster shield so that it extends 3/8" above the surface of
the finished floor.
•
Use an 8 mm allen wrench (not included) to remove the three
screws from the flush housing. Remove the flush housing. Do not
discard the screws.
•
Use the reserved screws to attach the trim to the rough. Pivot the
top of the trim so that the spout faces the correct direction. Use
a level to make sure that the unit is straight.
•
Seal the floor around the plaster shield with a waterproof,