Factory Direct Hardware Von Duprin 22EOF4 - Manual (Page 6)

911333_00(9) Page 6 of 12
3 Cut device if necessary.
If using ALK exit alarm option, install
ALK cover plate before cutting device.
NOTE !
Tape
Cover plate
Pushbar
Cover plate flush
with end of pushbar
A
B
Measure from
inside of stop Measure
from strike
Measure from end of center case cover
(not from tip of latch bolt)
4 Prepare door for device.
3.1. Device length A must be at least 1-1/2” shorter than B .
3.2. If necessary, cut device so A is at least 1-1/2” shorter than B .
RHR shown
LHR opposite
4.1. Cut center case template for 1409/1439
strike or for 299/299F/499F strike.
4.2. Tape center case template to inside of door
aligned with center line C as shown.
4.3. Mark and prepare holes per template.
4.4. Prepare door for outside trim (see trim
instructions).
299/299-F/499-F Strike 1409/1439 Strike
L
C
L
C
Place cut edge of
template against stop
L