Factory Direct Hardware Kwikset 907-S - Manual (Page 4)

Wire Harness
Small
Screws
Torque Blade
Important Note: To prevent damage, always handle the wire harness
with care.
4
Route wires down - avoiding any
excess bulge at curve, which could
interfere with battery pack installation.
5. Attach the Connector to the Interior Assembly.
Connector Port
Interior
Assembly
Connector
Connector
Wire Harness
a. Making sure wires are clear of pinching and wire harness is routed as
shown, place the interior assembly on door, aligning torque blade inside the
turnpiece shaft.
6. Install Interior Assembly.
Turnpiece
Shaft
b. Once flush on door,
insert and tighten small screws
to secure assembly onto the
mounting plate. Note: To aid insertion of screws,
approach the screw holes with the screw loaded onto the screwdriver.
a. Align the connector (smooth side up) with the connector port of the inte-
rior assembly.
c. Once aligned, push the connector in firmly to connect.
b. For easier orientation, view the alignment of connection from the top of
the interior assembly.
Top of
Interior
Assembly