Factory Direct Hardware Kwikset 907-S - Manual (Page 5)

AA
1
2
-
+
1
2
EXTERIOR
INTERIOR
LOCK
Button
Tab
Battery Pack
LED
5
c. Do not disturb the unit for approximately 20 seconds until the interior
Green LED flashes followed by a beep. During this time the system will drive
the bolt several times, will determine “door handing”, store data in memory
and exit. It is very important that this process is allowed to finish
properly.
8. Automatic - Bolt Direction Determination (Door Handing).
IMPORTANT: DO NOT SKIP THE FOLLOWING STEP.
LOCK WILL NOT BE ABLE TO OPERATE PROPERLY!
● In the steps below, the Smart-
Code mechanism automatically
determines the “door handing” and
sets the proper direction for motor to
rotate.
LEFT HAND DOOR
(LHD) (RHD)
RIGHT HAND DOOR
a. Press and hold the “LOCK” button on the exterior keypad, while fully in-
serting the battery pack into the interior assembly (the tabs on the pack must
face out - see illustration).
b. When the unit begins to operate the bolt, release the “LOCK” button.
7. Install batteries.
Alkaline Battery WARNING: Do not dispose of in fire, recharge,
put in backwards, disassemble, mix with used or other battery types. May
explode or leak and cause personal injury.
a. Install 4 new AA Alkaline batteries.
Install the new batteries as indicated in illustration. Make
sure batteries lie flat in holder. For best performance,
rechargeable batteries are not recommended.
Continued
 