Factory Direct Hardware Hansgrohe 14314 Talis C - Manual (Page 6)


Remove the plaster shield from the spout tee.
Remove the brass plug from the tee.
Three-hole models only:
Lightly lubricate the o-rings on the sealing ring us-
ing white plumbers grease.
Press the sealing ring into the spout tee.
Firmly press the spout over the sealing ring until it is
fully seated.
Tighten the screw using a 3 mm Allen wrench.
Do not overtighten the
screw.
Overtightening the screw
will deform the o-rings,
causing a leak.
3 mm