Factory Direct Hardware Toto HDR110#SS Clean Dry - Manual (Page 5)

STEP 2 － STEP 3
STEP 2 Complete the electrical wiring STEP 3 Mount the Chassis Assembly and Drain Tray
Assembly
※
Connection
Diagram
Connect the cord firmly with a wire nut or equivalent.
・
・ Make sure all electrical wiring is placed away inside the junction box.
Use 2 screws (M4) that come with the product and tighten unit to the bottom
bracket.
・ Place chassis assembly onto the bottom bracket.
・ Using wire nuts, connect power cable from hand dryer to power supply in the
junction box (confirm with certified electrician on correct wire nuts to use).
・ Place connection point (with wire nuts) into the junction box.
・ Hang chassis assembly onto the top bracket.
Connection point
(Actual Placement)
Junction box
Place mounting platform
onto mounting bracket hooks.
Place connection point (with
wire nuts) into the junction box
(Actual Placement)
Junction box
Chassis
Assy
Bracket (Top)
Bracket (Bottom)
Attach water tray after
installation is complete
Screw in two screws onto bottom
of body through the bottom bracket
(Actual Placement)
Junction box
Chassis Assembly
Drain tray