Factory Direct Hardware Pfister GT42-N00 - Manual (Page 2)

EN
G
LI
SH
ENGLISH
4
5
6
2
FAUCET INSTALLATION
3
Thank you for purchasing this Price Pfister product. All Price Pfister products are
carefully engineered, and factory tested to provide long trouble-free use under normal
conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-
Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3 TOOLS RECOMMENDED
• Plumber’s putty • Slotted screwdriver • Pliers
• Adjustable wrench • Flashlight • Cloth
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
4 FAUCET PREPARATION
Insert Lift Rod (4A) through the bottom of Faucet Body (4B) and vertically into Slot (4C)
on back of Spout (4D) as shown. Ensure that Seal Base (4E) is pressed onto Spout Base
(4F). Place Spout Base (4F) and Seal Base (4E) onto the bottom of Faucet Body (4B).
The Red and Blue Indicator (4G) can be switch with a solid colored Indicator (4H)
that is provided (See step 12).
5 FAUCET INSTALLATION
Following manufacturer’s recommendations on use, apply plumber’s putty into putty
groove in bottom of Seal Base (5A). With the handle and spout facing forward, carefully
insert Threaded Shank (5B) and Faucet Inlets (5C) through hole on sink.
For 3 hole Installation, order Deck Plate 961-095* separately.
6 SECURING FAUCET
From underneath sink, secure Faucet Body (6A) by placing Metal Washer (6B) and
threading Long Nut ( 7 /
16
“ Hex.) (6C) onto Threaded Shank (6D). Make sure that the
bumps on Metal Washer (6B) are facing up. Firmly hand tighten Long Nut (6C). Make
sure Lift Rod (6E) moves freely. Secure Long Nut (6C) not to exceed a quarter turn.
Caution: Do not over tighten!
2
4A
4C
4D
4C
4G
4H
4B
4E
4F
4A
5B
5A
5A
5C
6A
6B
6C
6E
6D
BOTTOM GROOVE
sample
copy