Factory Direct Hardware Pfister GT42-N00 - Manual (Page 3)

EN
G
LI
SH
ENGLISH
7
8
10
11
9
DRAIN BODY INSTALLATION
FAUCET FUNCTIONS
MAINTENANCE & CARE
7 WATER SUPPLY CONNECTIONS
Gently separate hot and cold Supply Tubes (7A), approximately three inches apart.
Connect water Supply Lines (7C) to Faucet Inlets (7B). Hot water supply line goes to hot
inlet fitting indicated by red tag (7D). (Supply lines not included). Follow manufacturer’s
instructions when installing supply lines.
Hold the Faucet Inlets (7B) steady using an adjustable wrench while tightening Supply
Lines (7C). Do not twist Supply Tubes (7A)!
8 DRAIN INSTALLATION
Install and adjust Drain (8A) using separate instructions supplied with the Drain
assembly.
9 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
10 FAUCET FUNCTION
By lifting the Lever Handle (10A) up, the valve will be activated allowing water to flow.
The water flow will increase by continuing to lift up the Lever Handle (10A). By rotating
the Lever Handle counter-clockwise, the water temperature will decrease to cold flow
only. By rotating the Lever Handle clockwise, the water temperature will increased to
hot flow only.
11 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (11A). Turn Valves (11B) on
and allow both hot and cold water to run for at least one minute each. While water is
running, check for leaks. To clean the aerator, disassemble Aerator Housing (11A) by
separating the Aerator Shell (11C), Basket (11D), and Washer (11E). Once parts have
been cleaned, reassemble by reversing steps.
3
7A
7A
7C
7C
7B
7B
7D
8A
10A
10A
11A
11B 11E
11D
11C
HOT
COLD
OPEN
HOT
COLD
sample
copy