SENA ProBee-ZE20S User Manual
Page 82
82
ProBee-ZE20S User Guide Rev.1.10
8.6
Firmware Upload
8.6.1
Local Node
# enter the bootloader menu for uploading firmware. Note that UART of local
node should be set to 115200-8-N-1-N.
AT+BOOTLOAD<CR>
Press ENTER...
SENA ProBee Bootloader v1.0
1. Upload Firmware
2. Run
3. View Firmware info
PROBEE >
# press “1” and upload ebl file by X-modem
begin upload
CCCCCCCCCCCCC
Serial upload complete
# press “2” or reset after upload is done
8.6.2
Remote Node
# upload firmware to a remote node using 64-bit long address. Note that UART
of local node should be set to 115200-8-N-1-N.
AT+BOOTLOAD=1,00019500002FDC40<CR>
Please start .ebl upload image ...
CCCCCCCCCCCCC
# upload ebl file by X-modem
Bootload Complete!
# succeed to upload