OSRAM PD MULTI 3 - Manual

OSRAM GmbH
Kunden Service Center
Customer-Service-Center (CSC)
Steinerne Furt 62
86167 Augsburg
Germany
Tel : +49 (0) 1803 677 - 200
(kostenpflichtig / charges apply)
Fax.: +49 (0) 1803 677 - 202
www.osram.com
www.osram.de
40503008021384
4050300802138
Light and motion sensor
Fitting instructions
II 2009
LSPD_Multi3_ma0902en_we1.01.indd
LS/PD MULTI 3
Description
Function and application
The LS/PD MULTI 3 sensor detects the presence of people and
measures the intensity of ambient light.
The sensor is installed in lamps.
Construction
The sensor is made up of the following components:
• Light sensor (A)
• Motion sensor (B)
• LED (C)
• Connection (D) for supply voltage, light measurement value,
motion signal and signal ground
• Housing (E)
Installation
Safety instructions
The sensor must only be installed and put into operation by a
qualified electrician. The applicable safety regulations and ac-
cident prevention regulations must be observed.
WARNING!
Exposed, live cables or damaged housing.
Danger of electric shock!
• Only work on the sensor when it is de-energized.
CAUTION!
Destruction of the sensor and other devices through
incorrect mounting!
• Only use OSRAM control units of the following
types: DALI MULTI 3/ DIM MULTI 3, DALI
MULTIeco/ MULTIeco, DALI PROFESSIONAL
Sensor Coupler.
• Do not connect control line with external voltage.
• Note the maximum total line length.
• Do not route the sensor line together with the
power or lamp line.
Connecting the sensor
Connect the sensor using the supplied cable or a commercially
available 4-pin cable. If the cable is shortened or lengthened,
ensure that the wiring is correct.
Sensors can be connected in parallel via a Y-branch. For the
maximum number of sensors: see the separate control unit
manual.
F Y-branch (optional)
G Sensor
Continued on the back page!
A B C
D E
DALI MULTI 3
Sensor F
G