SCANTECH ID (Champtek company) WD200 - Manual (Page 4)

1
Contents
Chapter 1 Description ............................................................ 3
1.1 General ................................................................ 3
1.2 Introduction ......................................................... 4
1.3 Codes Read .......................................................... 4
1.4 Installation ........................................................... 4
1.5 Pin Assignment ..................................................... 6
Chapter 2 Configuration - General ...................................... 8
2.1 Flow Chart ............................................................ 8
2.2 Loop of Programming .......................................... 9
2.3 Factory Default Settings ....................................... 9
2.4 Main Page of Configuration ............................... 10
Chapter 3 Interface and ..................................................... 11
3.1 Interface SeIection ............................................. 11
3.2 Reading Mode Selection .................................... 12
Chapter 4 Communication Parameters ................................. 13
4.1 RS232 Communication Parameters .................... 13
4.2 Keyboard Wedge Mode Parameters .................. 15
4.3 Output Characters Parameters .......................... 17
4.4 Wand Emulation Mode Parameters ................... 19
Chapter 5 Bar Codes & Others ............................................ 20
5.1 SymboIogies Selection ....................................... 20
5.2 UPC/EANI/JAN Parameters ................................. 24
5.3 Code 39 Parameters .......................................... 26
5.4 Code 128 Parameters ......................................... 28
5.5 Interleave 25 Parameters ................................... 30
5.6 IndustriaI 25 Parameters .................................... 32
5.7 Matrix 25 Parameters ........................................ 34
5.8 CODABAR/NW7 Parameters .............................. 36
5.9 Code 93 Parameters ........................................... 38
5.10 Code 11 Parameters ........................................... 40
5.11 MSI/PLESSEY Code Parameters .......................... 42
5.12 Code 2 of 6 Parameters ...................................... 44
5.13 LCD25 Parameters ............................................. 46
5.14 Telepen Parameters ........................................... 48
5.15 GS1 Databar ...................................................... 50
Chapter 6 Miscellaneous Parameters ................................ 52
6.1 Language Selection ............................................ 52
6.2 Bar Code ID ........................................................ 54
6.3 Reading Level ...................................................... 57
6.4 Accuracy ............................................................. 57
6.5 Buzzer Beep Tone ............................................... 57
6.6 Sensitivity of Continuous Reading Mode .............. 58
6.7 Reverse Output Characters ........................... 59
6.8 Setup Deletion ................................................. 59