SCANTECH ID (Champtek company) WD200 - Manual (Page 8)

5
Power supply for RS-232C scanner -
There are 3 ways to supplying the power, use
external +5V power supply, use optional power cable
(KBDC) which taking the power from KB wedge or if
the host supports +5V power from pin 9.
Installing the scanner to the Host System -
1. Turn off the host system.
2. Connect the power if needed.
3. Connect to the proper port on the host system.
4. Turn on the host system.
Switching cable -
Before removing the cable from the scanner, it is
recommended that the power on the host system is
off and the power supply has been disconnected
from unit.
1. Find the small "Pin-hole" on the bottom of the
unit.
2. Use a bended regular paperclip and insert the
tip into the hole.
3. You will head a "click", then gentle on the strain-
relief of the cable and it will slide out of the
scanner.
SG/LG Series
SD Series