QTech Data Systems Tait TM8000 Radio - Manual (Page 24)

En
g
lish
22 Troubleshooting
Removing the microphone
1 Using your thumb or forefinger, lift up one
of the corners of the microphone grom-
met. Firmly (but gently) pull that corner
until the seal comes away from the cavity.
2 Repeat to expose an adjacent corner.
3 Pull the exposed corners back and slide the grommet up
the microphone cable to reveal the microphone plug.
4 Remove the plug from the microphone socket.
Reinstalling the microphone
Caution: The microphone grommet must be installed when-
ever the microphone is plugged into the micro-
phone socket. When installed, the grommet has
two functions:
■
to prevent damage to the microphone socket
when there is movement of the microphone
cord, and
■
to ensure that the control head is sealed
against water, dust and other environmental
hazards.
To install the microphone:
1 Plug the microphone into the microphone socket.
2 Slide the microphone grommet along the microphone
cord and push two adjacent corners of the grommet into
the microphone socket cavity.
3 Squeeze the grommet and push the remaining corners
into position.
4 Check that the grommet is seated correctly in the cavity.
grommet
microphone
grommet
control head