GE Industrial Solutions Entellisys System User Manual - Manual (Page 227)

Alarms and events description and system troubleshooting guide 227
A
Caution Messngr Not Receiving
From CPUB Messenger reports that it is not receiving
data from CPU B Check Ethernet connection between
Entellisys Messenger and switch, and the
connection between the switch and the
CPU B. Verify that CPU B is powered on and
operating.
System OK Receiving Broadcast
From CPUA Messenger reports that it is receiving data
from CPU A
System OK Receiving Broadcast
From CPUB Messenger reports that it is receiving data
from CPU B
Test Mode Initiated From Test
Kit Messenger reports that test mode has been
initiated with the test kit
Test Mode Ended From Test Kit Messenger reports that test mode has ended
Protection Suspended GF From
Test Kit Messenger reports that ground fault
functionality is to be suspended
Protection Resumed GF From
Test Kit Messenger reports that ground fault
functionality can resume
Attention Compartment ID
Button Missing Messenger reports that it has detected that
the compartment ID button is missing See DEH-235 Entellisys Low Voltage
Switchgear EntelliGuard Messenger iButton
Replacement Guide.
Note Messngr Error 5 Compartment ID Button contains valid
configuration data, but EEPROM copy is bad See DEH-235 Entellisys Low Voltage
Switchgear EntelliGuard Messenger iButton
Replacement Guide.
Caution Check Compartment ID
Button Connection Messenger reports that the compartment ID
button connection needs to be checked See DEH-235 Entellisys Low Voltage
Switchgear EntelliGuard Messenger iButton
Replacement Guide.
Attention Messngr Error 1
Replace ASAP Messengr reports that its application flash
memory has a CRC error and should be
replaced Contact GE Post Sales Service (see How to
contact us on page 2 ).
Attention Messngr Error 2
Replace ASAP Messengr reports that its boot flash memory
has a CRC error and should be replaced Contact GE Post Sales Service (see How to
contact us on page 2 ).
Attention Messngr Error 3
Replace ASAP Messenger reports that it has an analog IOC
error and should be replaced Contact GE Post Sales Service (see How to
contact us on page 2 ).
Attention Messngr Error 4
Replace ASAP Messenger reports that it is not calibrated
and should be replaced Contact GE Post Sales Service (see How to
contact us on page 2 ).
CPU Status
Power On CPU has powered on
Discrete IO Test Mode Initiated Test mode for discrete I/O has been initiated
Discrete IO Test Mode Ended Test mode for discrete I/O has ended
Table A-2 Sequence of events description and troubleshooting guide
Event Description Notes and Troubleshooting tips