GE Industrial Solutions AF-600 FP Fan & Pump Drive (230V to 60HP, 460_575V to 125HP) - Manual (Page 26)

3.7 System Start Up
The procedure in this section requires user-wiring and
application programming to be completed. is intended to
help with this task. Other aids to application set-up are
listed in 1.2 Additional Resources. The following procedure
is recommended after application set-up by the user is
completed.
CAUTION
MOTOR START!
Ensure that the motor, system, and any attached
equipment is ready for start. It is the responsibility of the
user to ensure safe operation under any operational
condition. Failure to ensure that the motor, system, and
any attached equipment is ready for start could result in
personal injury or equipment damage.
1. Press [Auto].
2. Ensure that external control functions are
properly wired to the drive and all programming
completed.
3. Apply an external run command.
4. Adjust the speed reference throughout the speed
range.
5. Remove the external run command.
6. Note any problems.
If warnings or alarms occur, see 8 Warnings and Alarms.
Start Up and Functional Tes... AF-600 FP Operating Instructions
23
3 3