GE Industrial Solutions AF-600 FP High Power (460V_575V 150HP and above) - Manual (Page 119)

5. Remove the six retaining screws (T25) from the SCR/diode modules, terminals 2 and 3 in each module.
6. Remove the 4 (10 mm) retaining nuts from the DC inductor input bus bars and the 4 retaining nuts (not shown) from the side mounted bus bars. (Side
mounted bus bars are only present on units with load sharing.) Remove the DC input bus assembly.
130BX93.10
1
2
3
4
5
Illustration 7.1: 41/43 SCR/Diode Module (2 of 3)
1 Bus bar BB4
2 Retaining nuts (Step 6)
3 DC input bus assembly BB3 (Step 6)
4 Retaining screws (Step 5)
5 SCR/diode module
AF-650 GP and AF-600 FP High Power Service Manual
118
7