Net Optics Multi-Station Power Supply - Manual (Page 9)

Multi-Station Power Supply
5
Connecting the Multi-Station Power Supply to Net Optics Taps
1 . Unpack the Multi-Station Power Supply, and verify that you have all the
necessary components to successfully install the Taps .
2 . Connect one of the DC connector leads from Power 1 into the DC jack 1
on the first Tap. If present, remove the rubber cap from the barrel connec-
tor before plugging it into the Tap .
3 . Connect one of the DC connector leads from Power 2 into the DC jack 2
on the first Tap. If present, remove the rubber cap from the barrel connec-
tor before plugging it into the Tap .
Note: ________________________________________________________________
Each Tap should have a DC connector lead from both Power 1 and Power 2
in order to have power redundancy.
______________________________________________________________________
4 . Repeat Steps 2 and 3 above for connecting additional Taps to the Power
Module .
Connecting AC Input Power to the Multi-Station Power
Supply (AC model)
1 . If you have not already done so, unpack the Multi-Station Power Supply and
verify that you have two apropriate AC power cords .
2 . Connect one of the AC power cords to one of the AC power connector on
the rear of the Multi-Station Power Supply .
3 . Install a power supply clip over to keep the AC power cord from accidently
being unplugged from the AC power connector .
4 . Plug the other end of the cord into an AC power source .
5 . Repeat steps 2-4 for the other AC power cord, connecting it to the remaining
AC power connector on the rear of the Multi-Station Power Supply .