GC EUROPE Fujivest Super - Manual (Page 24)

24
Cooling down and devesting
Unless otherwise stated by the alloy manufacturer it is recommended that the cast mould is slowly
cooled to room temperature. This process can be helped by placing the warm cast mould into a cold
burnout furnace preventing the rapid dissipation of heat.
In order to prevent inhalation of silica particles and aid investment removal it is suggested that once
cool the mould is soaked in water for a few min.
GC Europe investments are specifically formulated to be removable from the cast parts with a minimum
of force, eradicating the need for excessive force or harsh abrasion.