Asus RS160-E5 - Manual (Page 20)

Chapter 2: Hardware setup 2-2
2.1 Chassis cover
2.1.1 Removing the front cover
1. Use a Phillips screwdriver to remove
the screw on each front end of the
front cover.
3. Firmly hold the front cover and slide
it toward the front panel for about
half an inch until it is disengaged
from the chassis.
2. Loosen the two thumbscrews on the rear panel to release the rear cover from
the chassis.
4. Released a drive tray by pushing
the spring lock to the right. Then ,
firmly hold the tray level and pull all
the drive trays out of the bay.
Thumbscrews