Asus RS160-E5 - Manual (Page 53)

3-3 ASUS RS160-E5
3.3 Attaching the rails to the rack
To attach the rails to the rack:
1. Select one unit of space (1U) on the rack
where you wish to install the barebone
server.
2. Remove the screws from the 1U space on
the rack front.
5. Find the rear 1U space that corresponds to the front 1U space where you
attached the rail.
6. Remove the screws from the rear 1U space, and align the rear end holes.
7. Drive in two screws on the outer holes to secure the rear end.
8. From the rack front, find the corresponding 1U space for the second rail pair.
9. Repeat steps 2 to 7 to attach the second rail pair. When properly installed,
the rack rails appear as shown.
3. Align the front end holes of a rack rail pair
to the 1U space.
4. Drive in two screws on the outer holes to
secure the front end.
1U space