Asus P5CR-L(S) - Manual (Page 89)

A S U S P 5 C R - L ( S ) A S U S P 5 C R - L ( S ) A S U S P 5 C R - L ( S ) A S U S P 5 C R - L ( S ) A S U S P 5 C R - L ( S ) 4 - 2 7 4 - 2 7 4 - 2 7 4 - 2 7 4 - 2 7
Allocate IRQ to PCI VGA [Yes] Allocate IRQ to PCI VGA [Yes] Allocate IRQ to PCI VGA [Yes] Allocate IRQ to PCI VGA [Yes] Allocate IRQ to PCI VGA [Yes]
When set to [Yes], BIOS assigns an IRQ to PCI VGA card if the card
requests for an IRQ. When set to [No], BIOS does not assign an IRQ to the
PCI VGA card even if requested. Configuration options: [Yes] [No]
Palette Snooping [Disabled] Palette Snooping [Disabled] Palette Snooping [Disabled] Palette Snooping [Disabled] Palette Snooping [Disabled]
When set to [Enabled], the palette snooping feature informs the PCI
devices that an ISA graphics device is installed in the system so that the
latter can function correctly. Configuration options: [Disabled] [Enabled]
PCI IDE BusMaster [Enabled] PCI IDE BusMaster [Enabled] PCI IDE BusMaster [Enabled] PCI IDE BusMaster [Enabled] PCI IDE BusMaster [Enabled]
Allows BIOS to use PCI bus mastering when reading/writing to IDE devices.
Configuration options: [Disabled] [Enabled]
IRQ-xx assigned to [PCI Device] IRQ-xx assigned to [PCI Device] IRQ-xx assigned to [PCI Device] IRQ-xx assigned to [PCI Device] IRQ-xx assigned to [PCI Device]
When set to [PCI Device], the specific IRQ is free for use of PCI/PnP
devices. When set to [Reserved], the IRQ is reserved for legacy ISA
devices. Configuration options: [PCI Device] [Reserved]
DMA Channel X [PCI Device] DMA Channel X [PCI Device] DMA Channel X [PCI Device] DMA Channel X [PCI Device] DMA Channel X [PCI Device]
When set to [PCI Device], the specific DMA channel is free for use of
PCI/PnP devices. When set to [Reserved], the DMA channel is reserved for
legacy ISA devices. Configuration options: [PCI Device] [Reserved]
4.4.6 4.4.6 4.4.6 4.4.6 4.4.6 Remote Access Configuration Remote Access Configuration Remote Access Configuration Remote Access Configuration Remote Access Configuration
The items in this menu allow you to configure the Remote Access features.
Select an item then press <Enter> to display the configuration options.
Configure Remote Access type and parameters
Remote Access [Disabled]
Serial port number [COM1]
Serial Port Mode [115200, 8,n,1]
Flow Control [None]
Redirection after BIOS POST [Always]
Terminal Type [ANSI]
VT-UTF8 Combo Key Support [Disabled]
Select Remote Access
type.