Asus RS100-E6/PI2 - Manual (Page 32)

Chapter 2: Hardware setup 2-14
3. Insert the hard disk drive into the
HDD bracket and secure it with four
screws.
5. Place the HDD bracket with the
hard disk drive installed into the
HDD tray 2, matching the four
screw holes. Then, secure the HDD
bracket with four screws.
4. Connect the SATA signal cable and
a power plug from the power supply
to the hard disk drive.
L-type SATA
connector
Use the L-type SATA connector
to connect to the hard disk drive.
6. Refer to section 2.7.2 Optical disk drive (ODD) to reinstall the ODD.
Power plug
SATA signal cable