Asus DSBF-DM/SAS - Manual (Page 95)

ASUS DSBF-DM Series 4-27
F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
ESC Exit →← Select Menu Enter Select Sub-Menu F10 Save and Exit
Item Specific Help
Configures the system
state after recovering
from power failure.
Power On Configuration
Restore on AC Power Loss [Last State]
Power On By PME# [Disabled]
Power On By RTC Alarm [Disabled]
PhoenixBIOS Setup Utility
Advanced
4.4.7 Power On Configuration
This menu shows the power configuration settings. Select an item then press
<Enter> to display the configuration options.
Restore on AC Power Loss [Last State]
When set to [Power Off], the system goes into “off state” after an AC power
interruption. When set to [Power On], the system turns on automatically after a
power interruption. When set to [Last State], the system goes into whatever was
the system state (on or off) before the power interruption.
Configuration options: [Power Off] [Power On] [Last State]
Power On By PME# [Disabled]
Allows you to enable or disable the PME and onboard LAN to generate a wake-up
event. Configuration options: [Disabled] [Enabled]
Power On By RTC Alarm [Disabled]
Allows you to enable or disable RTC to generate a wake-up event.
Configuration options: [Disabled] [Enabled]