Asus RS300-E8-RS4 - Manual (Page 32)

Chapter 2: Hardware setup 2-10
2.4 Hard disk drives
The system supports four hot-swap SATAIII/SAS hard disk drives and two SATAII
hard disk drives. The hard disk drive installed on the drive tray connects to the
motherboard SATA/SAS ports via the SATA/SAS backplane.
3. Take note of the drive tray holes.
Each side has three holes to fit
different types of hard disk drives.
Use two screws on each side to
secure the hard disk drive.
2. Firmly hold the tray lever and pull
the drive tray out of the bay.
spring lock
To install a hot-swap SATA/SAS HDD
1. Release a drive tray by pushing the
spring lock to the right, then pulling
the tray lever outward. The drive
tray ejects slightly after you pull out
the lever.