Asus P6T SE - Manual (Page 31)

ASUS P6T SE 2-11
Chapter 2
2.4.2 Memory configurations
You may install 1GB, 2GB and 4GB unbuffered and non-ECC DDR3 DIMMs into the DIMM
sockets.
• The default memory operation frequency is dependent on its SPD. Under the default
state, some memory modules for overclocking may operate at a lower frequency than
the vendor-marked value.
• For system stability, use a more efficient memory cooling system to support a full
memory load (6 DIMMs) or overclocking condition.
• You may install varying memory sizes in Channel A, Channel B and Channel C. The
system maps the total size of the lower-sized channel for the dual-channel or triple-
channel configuration. Any excess memory from the higher-sized channel is then
mapped for single-channel operation.
• Due to Intel spec definition, X.M.P. DIMMs and DDR3-1600 are supported for one
DIMM per channel only.
• According to Intel CPU spec, DIMMs with voltage requirement over 1.65V may
damage the CPU permanently. We recommend you install the DIMMs with the voltage
requirement below 1.65V.
• Always install DIMMs with the same CAS latency. For optimum compatibility, we
recommend that you obtain memory modules from the same vendor.
• Due to the memory address limitation on 32-bit Windows OS, when you install 4GB or
more memory on the motherboard, the actual usable memory for the OS can be about
3GB or less. For effective use of memory, we recommend that you install a 64-bit
Windows OS when having 4GB or more memory installed on the motherboard.
• This motherboard does not support DIMMs made up of 256 megabit (Mb) chips or
less.
P6T SE Motherboard
Qualified Vendors Lists (QVL) DDR3-2000MHz capability
Vendor Part No. Size
SS/
DS
Chip
Brand
Chip NO.
Timing
DIMM (BIOS)
Voltage
DIMM socket support
(Optional)
A*
B*
CORSAIR
BoxP/N:
TW3X2G2000DFNV
(CM3X1G2000DFNV)
(EPP)
2GB
(Kit of 2)
DS N/A
Heat-Sink
Package
8-8-8-24 1.9 •
OCZ OCZ3FXT20002GK
2GB
(Kit of 2)
SS N/A
Heat-Sink
Package
8 1.9 •
OCZ
OCZ3P20002GK
(EPP)
2GB
(Kit of 2)
SS N/A
Heat-Sink
Package
9 1.9 •
Gingle 9CAASS37AZZ01D1 2GB DS N/A
Heat-Sink
Package
9-9-9-24 •
Vendor Part No. Size
SS/
DS
Chip
Brand
Chip NO.
Timing
DIMM (BIOS)
Voltage
DIMM socket support
(Optional)
A*
B*
KINGSTON
KHX14900D3K3/3GX
(XMP)
3GB
(Kit of 3)
SS N/A
Heat-Sink
Package
(1333-9-9-9-24) 1.65 • •
Aeneon
AXH760UD10-18J
(XMP)
1GB SS N/A
Heat-Sink
Package
CL10
(1333-8-8-8-24)
• •
Aeneon
AXH860UD20-18J
(XMP)
2GB DS N/A
Heat-Sink
Package
CL10
(1333-8-8-8-24)
• •
P6T SE Motherboard
Qualified Vendors Lists (QVL) DDR3-1866MHz capability