Asus P6T SE - Manual (Page 69)

ASUS P6T SE 3-13
Chapter 3
3.5.2 CPU Ratio Setting [Auto]
Allows you to adjust the ratio between CPU Core Clock and BCLK Frequency. Use the <+>
and <-> keys to adjust the value.
Configuration options: [Auto] [12.0] [13.0] [14.0] [15.0] [16.0] [17.0] [18.0] [19.0] [20.0]
3.5.3 Intel(R) SpeedStep(TM) Tech [Enabled]
When set to [Disabled], the CPU runs at its default speed. When set to [Enabled], the CPU
speed is controlled by the operating system. Configuration options: [Disabled] [Enabled]
3.5.4 Intel(R) Turbo Mode Tech [Enabled]
Turbo mode allows processor cores to run faster than marked frequency in specific condition.
Configuration options: [Disabled] [Enabled]
The following two items appear only when you set the Ai Overclock Tuner item to
[Manual], [D.O.C.P.] or [X.M.P.].
BCLK Frequency [XXX]
Allows you to adjust the Internal Base Clock (BCLK). Use the <+> and <-> keys to adjust the
value. You can also type the desired value using the numeric keypad. The values range from
100 to 500.
PCIE Frequency [XXX]
Allows you to set the PCI Express frequency. Use the <+> and <-> keys to adjust the PCIE
frequency. The values range from 100 to 200.
DRAM O.C. Profile [DDR3-1805MHz]
This item appears only when you set the Ai Overclock Tuner item to [D.O.C.P.] and
allows you to select a DRAM O.C. profile, which applies different settings to DRAM
frequency, DRAM timing and DRAM voltage.
Configuration options: [DDR3-2006MHz] [DDR3-1805MHz]
eXtreme Memory Profile [High Performance]
This item appears only when you set the Ai Overclock Tuner item to [X.M.P.] and
allows you to select the X.M.P. mode supported by your memory module.
Configuration options: [High Performance] [High Frequency]
The configuration options for the following sub-item vary depending on the DIMMs you
install on the motherboard.
To obtain the best performance of the X.M.P. DIMM or 1600MHz DIMM, install only one
DIMM on each memory channel.