Zanussi ZFC623WAP User Manual

Page 41

Advertising
background image

Problem

Possible cause

Solution

The temperature of the room that

contains the appliance is too high for

efficient operation.

Try to reduce the temperature in the

room where the appliance stands.

The High temperature alarm

light is on.

It is too warm inside the freezer.

Refer to "High Temperature Alarm".

The cabinet has been recently

switched on and the temperature is

still too high.

Refer to "High Temperature Alarm".

There is too much frost and ice. Products are not wrapped properly.

Wrap the products better.

The lid is not shut properly or do not

close tightly.

Check if the lid closes well and the

gaskets are undamaged and clean.

The temperature is not set correctly.

Set a warmer temperature.

The water drainage plug is not cor-

rectly positioned.

Position the water drainage plug in the

correct way.

The lid doesn't close complete-

ly.

There is excessive frost.

Eliminate excess frost.

The lid gaskets are dirty or sticky.

Clean the lid gaskets.

Food packages are blocking the lid.

Arrange the packages in the right way,

see the sticker in the appliance.

The lid is difficult to open.

The lid gaskets are dirty or sticky.

Clean the lid gaskets.

The valve is blocked.

Check the valve.

The lamp does not work.

The lamp is defective.

Refer to "Replacing the lamp".

It is too warm in the freezer.

The temperature is not set correctly.

Set a lower temperature.

The lid does not close tightly or it is

not shut properly.

Check if the lid closes well and the

gasket is undamaged and clean.

Before freezing the appliance was not

precooled sufficiently.

Pre-cool the appliance for enough

time.

Large quantities of food to be frozen

were put in at the same time.

Wait some hours and then check the

temperature again. Next time insert

smaller quantities of food to be frozen

at any one time.

Food placed in the appliance was too

warm.

Allow food to cool to room tempera-

ture before storing.

Products to be frozen are placed too

closely to each other.

Place the products in a way so that

cold air could circulate among them.

The lid has been opened often.

Try to not open the lid often.

The lid has been opened for a long

time.

Do not leave the lid open longer than

necessary.

41

Advertising