Asus NCCH-DLE - Manual (Page 115)

5 - 3 5 - 3 5 - 3 5 - 3 5 - 3 A S U S N C C H - D L E A S U S N C C H - D L E A S U S N C C H - D L E A S U S N C C H - D L E A S U S N C C H - D L E
5.1.4 5.1.4 5.1.4 5.1.4 5.1.4 Adaptec Adaptec Adaptec Adaptec Adaptec ® ® ® ® ® RAID configuration utility RAID configuration utility RAID configuration utility RAID configuration utility RAID configuration utility
You can create a RAID set using the A d a p t e c R A I D C o n f i g u r a t i o n A d a p t e c R A I D C o n f i g u r a t i o n A d a p t e c R A I D C o n f i g u r a t i o n A d a p t e c R A I D C o n f i g u r a t i o n A d a p t e c R A I D C o n f i g u r a t i o n
U t i l i t y U t i l i t y U t i l i t y U t i l i t y U t i l i t y, if you installed SATA hard disk drives on the SATA connectors
supported by the Intel
® 6300ESB Southbridge.
The Adaptec RAID Configuration Utility allows you to create RAID 0, RAID 1,
and JBOD configurations using the SATA hard disk drives connected to the
SATA connectors supported by the motherboard Southbridge chip.
To enter the Adaptec RAID Configuration Utility:
1. Turn on the system after installing all the SATA hard disk drives.
2. During POST, the Adaptec HostRAID™ technology automatically
detects the installed SATA hard disk drives and displays any existing
RAID set(s). Press <Ctrl> <A> to enter the utility.
The A r r a y C o n f i g u r a t i o n U t i l i t y A r r a y C o n f i g u r a t i o n U t i l i t y A r r a y C o n f i g u r a t i o n U t i l i t y A r r a y C o n f i g u r a t i o n U t i l i t y A r r a y C o n f i g u r a t i o n U t i l i t y menu lets you create and
manage RAID sets. The D i s k U t i l i t i e s D i s k U t i l i t i e s D i s k U t i l i t i e s D i s k U t i l i t i e s D i s k U t i l i t i e s allows you to check and verify
SATA hard disk drives.
At the bottom of the screen is the legend box. The keys on the
legend box allow you to navigate through the setup menu options or
execute commands. The keys on the legend box vary according to the
menu level.
3. Use the arrow keys to highlight an option.