Armasight NRWVULCAN239DA1 Vulcan 2.5-5x Gen 3 Alpha MG Night Vision Riflescope - Manual (Page 19)

19
3.1.2 IR850 BATTERY INSTALLATION
CAUTION :
Before installing a battery, verify that the device is OFF.
Install the CR123A battery as follows (refer to Figure 3-3):
1. Unscrew the battery cap (A).
3. Install the battery (B) into the battery compartment. Align the plus sign on the battery with the plus
sign on the cap face.
4. Replace the battery cap (A).
3.1.3 INSTALLING THE VULCAN ON A WEAPON
WARNING :
When installing the equipment on a weapon, verify that the weapon is clear and that the safety
is on before proceeding.
To install the Vulcan on a Picatinny/ Weaver rail, perform the following:
1. Unlock the clamping device of the Vulcan mount by pushing down on the lever holders (A, see Fig-
ure 3-4) and unlocking the levers (B).
2. Install the Vulcan on the Picatinny/ Weaver rail so that the stops (A, see Figure 3-5) slide into the
transverse slots on the rail.
BAttERy CAP
FIGURE 3-2. BATTERY ADAPTER POSITIONS IN THE BATTERY CAP
CR123A
AA
BAttERy ADAPtER
BAttERy CAP
BAttERy ADAPtER
B
A
FIGURE 3-3. IR850. BATTERY INSTALLATION