Armasight NRWVULCAN239DA1 Vulcan 2.5-5x Gen 3 Alpha MG Night Vision Riflescope - Manual (Page 20)

20
3. Affix the Vulcan to the rail by locking the levers (B, Figure 3-4).
4. Verify that the clamping device is firmly holding the Vulcan. If necessary, adjust the clamping de-
vice’s lever-cam locks as detailed in Part 3.1.4 (Clamping Device Adjustment).
3.1.4 CLAMPING DEVICE ADjUSTMENT
To adjust the mount’s clamping device, do the following:
1. Remove the Vulcan from the weapon.
B A
FIGURE 3-6. CLAMPING DEVICE ADjUSTMENT
2. With the clamping device unlocked (as shown in Figure 3-6), push the cam (B) towards the arrow,
which will cause the nut (A) to slide out of its hole.
B
A
lOCKED
POSItIOn
B
A
FIGURE 3-4. VULCAN MOUNT. TOP VIEW
unlOCK
POSItIOn
A
FIGURE 3-5. VULCAN MOUNT. UNDERSIDE VIEW
unlOCK
POSItIOn