Armasight NRWVULCAN239DA1 Vulcan 2.5-5x Gen 3 Alpha MG Night Vision Riflescope - Manual (Page 22)

22
Mount the IR850 on the Weaver rail as follows:
1. Loosen the nut (D). Install the mount (B) on the Weaver rail so that the stop (C) slides into one of the
transverse slots of the rail.
2. Tighten the nut (D) using a screwdriver.
3.1.7 INSTALLING THE 2X AFOCAL LENS
To mount the 2X afocal lens to the Vulcan, screw it into threading of the riflescope’s objective lens.
NOTE:
After installing the afocal lens, you will need to readjust windage and elevation.
3.2 CONTROLS AND INDICATORS
CAUTION:
DO NOT force the equipment controls past their stopping points.
3.2.1 VULCAN CONTROLS AND INDICATORS
The Vulcan controls are shown in Figure 3-9.
The Vulcan controls and indicators are defined in Table 3-1. The ITEM NO. column indicates the number
used to identify items in Figure 3-9.
The Vulcan controls described elsewhere in this manual (levers and nuts of the clamping device) are
not included in this section.
1
FIGURE 3-9. VULCAN CONTROLS
4
2
3
5
6 7
8