AVSL 173.278 CCT400 - Manual

CCT400
MINI CLIP TUNER
Item ref: 173.278
User Manual
Getting started

Install the supplied CR2032 button cell into the rear compartment with positive side facing outward

Clip the CCT400 to the headstock or a part of the instrument where vibrations can be detected

Rotate the display so that it can be seen clearly during tuning.
Operation

The CCT400 has a single button operation

Press the button for 3 seconds to switch on/off

A short press of the button switches through the tuning modes.

Play a note and the detected pitch will be represented on the virtual needle display

If the note is not detected, try another clip location on the instrument

Needle to the left indicates “flat” and to the right indicates “sharp”

Needle in the centre indicates “in-tune”, confirmed by the backlight changing to green

If no note or button press is detected for 3 minutes, the unit will switch off automatically
Specifications
Power supply 3Vdc (CR2032 button cell)
Tuning modes Chromatic, Guitar, Bass, Violin and Ukulele.
Tuning range A0 (27.5Hz) - A6 (1760Hz)
Tuning stability ±0.5 cent
A4 frequency 440Hz (fixed)
Dimensions 33 x 53 x 40mm
Weight 22g

If the unit stops responding or the display “freezes”, remove the battery and then replace it again

Avoid damage through impact, heat and keep away from liquids or direct sunlight

If display becomes dim, replace the CR2032 button cell
Errors and omissions excepted.
Copyright© 2012. AVSL Group Ltd.