AVSL 173.269 CCT45 - Manual

www.chordmusic.co.uk
CCT45 CLIP TUNER
(173.269)
User Manual
Important

Avoid exposure to high temperature, direct sunlight, moisture, strong magnetic fields and corrosive materials

Clean only with a dry, lint-free cloth and avoid rough handling or impact

Remove battery when not being used for long periods of time
Function buttons

Press the ON/OFF button to switch on the tuner

The display will illuminate completely and then enter the tuning mode (whichever has been previously selected)

Press the MODE button to scroll through the tuning modes (instrument types)

Press the ON/OFF button to switch the tuner off.

If no buttons are pressed and no tuning vibrations detected for 3 minutes, the tuner will power down automatically
Tuning

Switch on and select the correct mode for the instrument that requires tuning (see above)

Clip the tuner onto the instrument where it can pick up vibrations (e.g. on the headstock)

Rotate the display so that it can be seen during tuning adjustment

Play a note and check that the display to see if a note is detected

If no note is detected, adjust the tuning on the instrument or move the clip to another position until a note is detected

Adjust the tuning on the instrument until the required note is indicated (display shows string number and musical note)

Tuning accuracy is displayed via a virtual needle which is to the left when the note is flat and to the right when it is sharp

When the note is exactly in tune, the needle points to the centre and the backlight changes colour to green.

Repeat the tuning process for all strings and repeat again if strings need settling in or stretching
SPECIFICATIONS
Power supply 1.5V button cell (CR2032 supplied)
A4 frequency 440Hz
Frequency stability ±0.5cent
Tuning modes Chromatic, Guitar, Bass, Violin, Ukulele
Tuning range A0 (27.5Hz) to A6 (1760Hz)
Dimensions (not inc. antenna) 38 x 60 x 43mm
Weight (without battery) 40g
Troubleshooting
Display does not light or lights very dimly Change battery for a new one
Display freezes and will not respond Remove and replace battery after 30 seconds and try functions again
Tuner cannot detect notes
Move clip to a new position where vibrations can be detected
Adjust tuning of instrument up and down in pitch until a note is detected
Change battery for a new one if suspected to be low on charge
© Chord 2011