Xylem 19 001 251 R3 Floboy VFD Pumping System - Manual (Page 11)

7
HANDLING
Qualified personnel should unload and handle
the unit. Prevent damage due to dropping or
jolting when moving the unit. Thoroughly inspect
the unit for damage upon receipt. Immediately
notify the carrier of transportation damage.
Ensure that sensing lines are free of crimps and
kinks.
The unit is top heavy due to the position of the
equipment. Do not use component eyebolts to
lift the pump station.
WARNING: Falling Objects Hazard
Eyebolts, if provided, are designed to lift only
the components to which they are attached.
Failure to follow these instructions could result
in serious personal injury, death, and/or
property damage.
STORAGE
During periods of storage, the unit should be
covered to prevent corrosion and contamination
from dirt. Store the unit in a clean, dry location to
prevent condensation and freezing. After
storage, check that it is dry before applying
power. Specific component storage instructions
must be followed in accordance with the
respective equipment manufacturer's
recommendations.
CAUTION: Extreme Temperature Hazard
Extreme temperatures are to be avoided.
(Below 32ºF and above 110ºF.)
Failure to follow these instructions could result
in serious property damage and/or moderate
personal injury.
FIELD CONNECTION DIAGRAMS
Actual equipment manufacturers/models
installed are system specific. Refer to specific
manufacturers’ Installation, Operation &
Maintenance Manuals for details unique to each
component. The pump instruction manual is
supplied with the system (if applicable).
Review the wiring diagrams and dimensional
drawings prior to unit installation and operation.
Typical wiring diagrams are included in
Appendix D.
NOTE: Electrical supply must match the control
panel nameplate specification. Incorrect voltage
can cause fire, damaging electrical components
and void the warranty.
NOTE: Electrical supply must be installed by a
qualified electrician in accordance with all
applicable codes, ordinances, and good
practice.
GROUND CONNECTIONS
A grounding terminal is provided for a dedicated
ground wire connection. All provisions of the
National Electrical Code and local codes must
be followed.
WARNING: Electrical Shock Hazard
Conduit grounds are not adequate. A separate
ground wire must be attached to the ground lug
provided in the enclosure to avoid potential
safety hazards.
Failure to follow these instructions could result
in serious personal injury or death, or property
damage.