Xylem IM125 R02 RJA & RJDS Quick Set - Manual (Page 2)

2
NOTICE
All electrical work must be performed
by a qualified technician. Always follow
the National Electrical Code (NEC), or the Canadian
Electrical Code, as well as all local, state and provincial
codes. Code questions should be directed to your local
electrical inspector. Failure to follow electrical codes and
OSHA safety standards may result in personal injury or
equipment damage. Failure to follow manufacturer’s
installation instructions may result in electrical shock,
fire hazard, personal injury or death, damaged equip-
ment, provide unsatisfactory performance, and may void
manufacturer’s warranty.
Standard units are not designed for use in
swimming pools, open bodies of water,
hazardous liquids, or where flammable gases exist. Well
must be vented per local codes. See specific pump catalog
bulletins or pump nameplate for all agency Listings.
Disconnect and lockout electrical power
before installing or servicing any electrical
equipment. Many pumps are equipped with automatic
thermal overload protection which may allow an over-
heated pump to restart unexpectedly.
Never over pressurize the tank, piping or
system to a pressure higher than the tank's
maximum pressure rating. This will damage the tank,
voids the warranty and may create a serious hazard.
Protect tanks from excessive moisture and
spray as it will cause the tank to rust and
may create a hazard. See tank warning labels and IOM
for more information.
WARNING
WARNING
WARNING
Important notice: Read safety instructions before proceeding with
any wiring
SAFETY INSTRUCTIONS
TO AVOID SERIOUS OR FATAL PERSONAL INJURY
OR MAJOR PROPERTY DAMAGE, READ AND
FOLLOW ALL SAFETY INSTRUCTIONS IN MANUAL
AND ON PUMP.
THIS MANUAL IS INTENDED TO ASSIST IN THE IN-
STALLATION AND OPERATION OF THIS UNIT AND
MUST BE KEPT WITH THE PUMP.
This is a SAFETY ALERT SYMBOL.
When you see this symbol on the pump
or in the manual, look for one of the
following signal words and be alert to the
potential for personal injury or property
damage.
Warns of hazards that WILL cause serious
personal injury, death or major property
damage.
Warns of hazards that CAN cause serious
personal injury, death or major property
damage.
Warns of hazards that CAN cause personal
injury or property damage.
NOTICE: INDICATES SPECIAL INSTRUCTIONS
WHICH ARE VERY IMPORTANT AND MUST BE
FOLLOWED.
THOROUGHLY REVIEW ALL INSTRUCTIONS
AND WARNINGS PRIOR TO PERFORMING ANY
WORK ON THIS PUMP.
MAINTAIN ALL SAFETY DECALS.
DANGER
CAUTION
WARNING
WARNING
WARNING
Table of Contents
Section 1 – Installing a New Shallow Well Pump ................................................................................................................4
Section 2 – Installing or Replacing a Shallow Well Pump ..................................................................................................4
Section 3 – Deep Well Installations - Introduction .............................................................................................................6
Section 4 – Installing a New Deep Well ...............................................................................................................................6
Section 5 – Installing or Replacing a Deep Well Pump .....................................................................................................7
Section 6 – Maintenance .......................................................................................................................................................9
Section 7 – Pressure Tanks and Piping ...............................................................................................................................10
Section 8 – Troubleshooting Checklist ..............................................................................................................................11
Section 9 – Repair Parts .......................................................................................................................................................14
CAUTION
WARNING
CAUTION
PRE-INSTALLATION CHECK
Before you start on a new residential water
well system, check state and local well
codes and plumbing requirements. Be sure your well is the
required minimum distance away from sources of contami-
nation such as cistern, septic tank field, field tile, etc.
Always disinfect the well and test well
water for purity before using. Check with
your local Health Department for testing procedures.
Make sure your well is covered with a
pitless adapter or sanitary well seal to
prevent contamination and pump damage.
Always drain the pump and tank during
extended periods of non-use when below
freezing temperatures exist.