Xylem IM112 AquaBoost 1AB1 & 2AB1 Variable Speed Pump Controllers - Manual (Page 4)

4
WARNING
Hazardous voltage
can shock, burn or
cause death.
Safety Instructions
DANGER
WARNING
CAUTION
4
Important: Read all safety information prior to installation of the
AquaBoost Controller.
Note
This is a SAFETY ALERT SYMBOL. When you see this symbol on the pump or in the manual,
look for one of the following signal words and be alert to the potential for personal injury or
property damage.
Warns of hazards that WILL cause serious personal injury, death, or major property
damage.
Warns of hazards that CAN cause serious personal injury, death, or major property
damage.
Warns of hazards that CAN cause personal injury or property damage.
NOTICE Indicates special instructions which are very important and must be followed.
1. This manual is intended to assist in the installation, operation, and repair of the AquaBoost Controller and
must be kept with the AquaBoost Controller.
Note
All operating instructions must be read, understood, and followed by the operating personnel.
Goulds Pumps accepts no liability for damages or operating disorders which are the result of
non-compliance with the operating instructions.
2. To avoid serious or fatal personnel injury or major property damage, read and follow all safety
instructions in this manual.
3. Installation and maintenance MUST be performed by properly trained and qualifi ed personnel.
4. Review all instructions and warnings prior to performing any work on the AquaBoost Controller.
5. Any safety decals MUST be left on the AquaBoost Controller unit and pump.
Note
Inspect AquaBoost Controller for any damage after unpacking from shipping crates. Report any
damage immediately to the carrier or distributor/dealer immediately.
6. In addition to instructions contained in this manual, you must meet any local safety, electrical or plumbing
codes and requirements. Installation, maintenance or repair work must only be carried out by trained,
skilled and qualifi ed personnel.
7. The AquaBoost Controller drive head must be disconnected from the main power supply before
attempting any operation in the electrical or mechanical part of the system.
Note
When in operation, the motor can be stopped, but power remains at the drive head. The motor
and pump could start unexpectedly and produce serious injury. When the Aquaboost Controller
drive head is connected to the main power supply, the inverter power supply and master control
unit are also connected to the power supply.
WARNING!
FAILURE TO DISCONNECT ELECTRICAL POWER BEFORE ATTEMPTING ANY MAINTENANCE
CAN CAUSE SHOCK, BURNS OR DEATH.