YSI IQ S ENSOR N ET System 182 User Manual
Page 54
Advertising
Installation
System 182
3 - 40
ba76022e01
12/2011
Connecting lines to the
terminal strip
Fig. 3-31 Inserting lines
Note
The complete assignment of the terminal strip is shown in section 3.12.
11
Open the enclosure of the Universal Transmitter.
12
Screw a cable gland (pos. 1 in Fig. 3-31) with the sealing ring
(pos. 2) into the enclosure below the respective connections.
13
Loosen the coupling ring (pos. 3).
14
Feed the line through the cable gland in the enclosure.
15
Connect the wires to the terminal strip. While doing so, pay
attention to the specifications on the label located under the
terminal strip.
16
Tighten the coupling ring (pos. 3).
1
3
2
Advertising