YSI Pro20 - Manual (Page 19)

15
TEMPERATURE UNITS
Highlight Temperature Units and press enter to open a submenu that will allow
you to change the temperature units displayed in the run screen. Highlight the
desired unit (Celsius or Fahrenheit) and press enter to enable. The enabled
temperature unit will have an ‘X’ in the box next to it. Only one unit may be
enabled at a time. Highlight the ESC-Exit box and press enter to save any changes
and to close the Temperature Units submenu.
PRESSURE UNITS
Highlight Pressure Units and press enter to open a submenu that will allow you to
change the units displayed on the run screen. Highlight the desired unit (mmHg,
inHg, mbar, psi, or kPa) and press enter to enable. The enabled pressure unit will
have an ‘X’ in the box next to it. Only one unit may be enabled at a time.
Highlight the ESC-Exit box and press enter to save any changes and to close the
Pressure Units submenu.
LANGUAGE
Highlight Language and press Enter to open a submenu that will allow you to
change the language. Highlight the desired language (English, Spanish, German,
or French) and press enter to enable. The enabled language will have an ‘X’ in the
box next to it. Highlight ESC-Exit box and press enter to save any changes and to
close the Language submenu.
The text in the boxes along the bottom of the run screen will always be displayed
in English regardless of the language enabled in the System Setup menu.
AUTO SHUTOFF
Auto Shutoff allows you to set the instrument to turn off automatically after a
period of time. Use the up or down arrow keys to highlight Auto Shutoff, then
press enter to open the submenu. Press enter while the minute field is highlighted
to make it adjustable. Next, use the up and down arrow keys to adjust the shut off
time from 0 to 60 minutes. Press enter to confirm and save the new shutoff time.
Highlight ESC-Exit box, then press enter to close the Auto Shutoff submenu.
To disable Auto Shutoff, set the Time in Minutes to 0 (zero).