Xylem FC220 OPEN CHANNEL FLOW MONITOR - Manual (Page 17)

Global Water
800-876-1172
• globalw.com
- 17 -
Totalizer Reset:
The Totalizer Reset menu allows the totalizer to
be reset to zero. The reset is password protected.
This menu also allows the password to be changed. When shipped from the factory
the password is set to 1234. Press the RIGHT arrow to enter the password. Use the
LEFT and RIGHT arrows to select each digit, and use UP and DOWN to scroll
through the numbers. Press MENU to move forward provided that the password was
entered correctly. If the password is lost or forgotten, contact the Global Water
Technical Support department. If you want to reset the totalizer counter to zero, use
UP or DOWN to select YES, then SAVE. If you do not want to reset the counter,
select NO. Press Menu to move forward. If you said YES you must confirm the reset,
use UP or DOWN to select yes, then SAVE and MENU. If you want to change the
password, use UP or DOWN to select YES, then SAVE and MENU. Use the LEFT
and RIGHT arrows to select each digit and use UP and DOWN to scroll through the
numbers. Press SAVE and MENU. Confirm the new password by entering it again in
the same manner as before.
XII. Data Logger Option
A factory option for the FC220 is an internal data logger which records a historical
record of water flow, and records the exact time of each relay pulse. Channel one of
the data logger records flow and channel two records relay events. A special software
package allows the programming of the logger and the download of recorded flow and
relay data. This software differs from other Global Water data logger software in the
way it processes the relay data. Software such as Global Logger II will work with the
FC220 data logger option but some relay information will not be seen. The data logger
is factory calibrated and should not need to be recalibrated again. Should you need to
recalibrate the logger, consult the Data Logger Option manual.