Xylem SDI-12 Data Logger iRIS 220, iRIS 320, iRIS 350, iRIS 150, iRIS 300 - Manual (Page 25)

19 iQuest (NZ) Ltd - PO Box 15169, Hamilton, New Zealand Tel: +64 7 857-0810 Fax: +64 7 857-0811 Email: [email protected]
4.4.3 Comms Cfg (Level 2)
The comms configuration menu is the starting point for configuring all iRIS communication settings:
* Comms Cfg
0 Exit
1 Force GPRS Online [Yes]
2 Addr [1]
3 Base Type [HydroTel]
4 GPRS Cfg
5 RS232 Cfg [9600bps, Base 0, Gateway 0]
6 Phone List
7 Call-back [IP]
8 Modem Terminal
9 SDI-12 Terminal
>
Option 0 - Exit
Select this option to return to the Main Menu.
Option 1 – Force GPRS Online or Connect/Disconnect or N/A
This prompt will only show the “Force” option is the unit is a GPRS model AND the comms
scheduler is disabled (i.e. it has a duration setting of zero). In all other situations, it will show
either “Connect” or “Disconnect” to simply start or end a wireless connection or “N/A” if the
option is not valid for any reason.
If it is able to be forced, when this option is selected you will be prompted to wither enable or disable a
forced, continuous IP communication session. As mentioned, this option is only available for GPRS models
where a “permanent “connection is possible.
> Force Online (0:No 1:Yes)=
Enter either 0 to disable communication or 1 to enable a permanent GPRS communication session. Set this
option to 0 (disabled) when using the Schedule feature to define a regular regime of automatic connections.
See Section 4.4.7.
Option 2 -Addr
When this option is selected you will be prompted to enter the iQuest protocol address for the device.
> Address=
Enter a value between 0 and 32767 (the factory default is 1). This address is used to identify the unit in all
iQuest protocol communications.
An address of 0 is normally reserved for the base station (e.g. HydroTel™). The iRIS will
always respond to an address of –3, which is a special universal address.
Option 3
This option selects the type of base station to which iRIS will be connected.
> Type (0:HydroTel 1:Other)=
If you are connecting to a HydroTel™ base station (including the iQuest Global Data Network), set this value
to 0 (HydroTel), otherwise set it to 1 (Other) for other host systems such as the iQuest iRIS Web Agent that
accept auto-reported data. This option affects the format of unsolicited messages sent to the base station.
Option 4
Select this option to enter the GPRS/3G/CDMA-1X configuration menu.