Xylem SDI-12 Data Logger iRIS 220, iRIS 320, iRIS 350, iRIS 150, iRIS 300 - Manual (Page 95)

89 iQuest (NZ) Ltd - PO Box 15169, Hamilton, New Zealand Tel: +64 7 857-0810 Fax: +64 7 857-0811 Email: [email protected]
15.4 Connecting the iRIS-CAM
Connecting the camera to the datalogger is a simple process. First disconnect all power to the logger then
feed the camera cable through the gland. Next connect the iRIS-CAM 6 way connector to the camera port on
the iRIS circuit board. This is located next to the SIM card carrier on the iRIS 350. For the iRIS 320 model,
install the camera adaptor PCB and connect the camera to the port on the adaptor. Finally tighten the gland
and re-power the logger.
The easiest way to commission the iRIS-CAM is to connect it to the USB port of a laptop or desktop PC. This
allows quick and repetitive collection of images from the camera, enabling quick focusing and alignment of
the camera.
It is important to install the Windows® iRIS-CAM USB adapter drivers before connecting the
camera to the PC.
15.5 Installing PC Based Software & USB Drivers
The following list of steps will install the iRISCamera commissioning software and the Windows® USB
drivers for the iRIS-CAM adaptor.
1. Obtain the installation package from iQuest.
1
2. For the CD distribution:
a. Insert CD into PC’s CDROM drive. If the installer does not automatically start, then run it
manually from d:\ iRISCAMInstaller.exe (where d:\ is the CDROM drive letter).
b. Click on Install iRIS-CAM button and follow the prompts.
3. For a Web download:
a. Download the iRIS-CAM windows software installer package from www.iquest.co.nz
b. Run the iRISCAMInstaller.exe program and follow the instructions.
4. Once installation of the iRISCamera Software is complete and the installation program has been
closed, install the USB drivers by:
a. Run the installer from Start->All Programs->iRIS-CAM->USB Driver Installer.
b. Click Install button.
If you are prompted with the message saying the software has not passed Windows Logo
Verification, please ignore and click the Continue Anyway button.
1
Software can be obtained from CD or the iQuest website: www.iquest.co.nz
iRIS-CAM 6 way
Connector on
iRIS 350