Xylem inoLab 7110 WASTEWATER pH METER - Manual (Page 29)

pH 7110 Settings
ba75925e02 12/2011 29
7 Settings
The meter has separate setting routines for the measurement settings and
system settings.
7.1 Measurement settings (pH)
7.1.1 Changing the settings for pH measurements
1. Open the setting menu in the measured value display with <M__>.
The first setting is displayed.
2. If necessary, indicate the required setting with <ENTER>.
3. To change the current setting, press <><>.
4. Confirm the setting with <ENTER>.
The next setting is displayed.
5. Change or confirm the other settings.
or
Quit the setting menu with <M>.
The settings are stored.
Settings for pH measurements
Default settings are printed in bold.
The settings appear in the following order:
When the last setting is confirmed, the setting menu is auto-
matically quit.
Displayed
(Confirm with
<ENTER>)
Possible setting
(Change with
<
><>)
Description
pH bUFF pH
U Display during calibration
Nominal buffer value (pH) or
Electrode voltage (U)
pH SLO mV/pH
% Unit of the value for the slope
pH ASY mV
pH Unit of the value for the zero point