Xylem WTS - Manual (Page 11)

Operating instructions
WTS 102/3-en 9
Automatic Control
• Automatic Operations can be attained by fitting a mercury level switch (e.g. Type NGE) or an
electrode switch.
• The switching device needed to turn the motor on and off (circuit breaker ,Y-∆-automatic circuit
breaker) must be suitable for momentary contact control.
• An alarm switch functioning independently of the mains can be fitted if desired.
3. Transport, Handling, Storage
3.1 Transport, Handling
• Check the pump/pump unit immediately upon delivery/receipt of despatch for damage or
missing parts.
• The pump/pump unit must be transported carefully and by competent personnel. Avoid serious
impacts.
• Keep the pump/pump unit in the same position in which it was supplied from the factory. Take
note of the instructions on the packaging.
• The intake and discharge side of the pump must be closed with plugs during transport and
storage.
Dispose of all packing materials in accordance with local regulations.
• Lifting devices (e.g. fork-lift truck, crane, crane device, pulleys, sling ropes, etc.) must be
sufficiently strong. The weight of the pump/pump unit is given in the Data Sheet.
• The unit may only be lifted by the hooks provided (on the upper side of the base plate). The
following illustration shows the correct method of carrying by crane.
Sling ropes must not be fixed to ends of shafts or the ring
loops of the motor.
Do not stand underneath suspended loads; take note of the
general regulations on prevention of accidents.
The pump/pump unit must be secured against tipping over and
slipping until it has been fixed in its final location.
Please
note
Please
note