Extron Electronics DMP 128 User Guide User Manual
Page 105
3.
To move away from the highlighted block or set of sequential blocks, or to highlight
non-sequential blocks:
a.
After highlighting blocks in step 2, press and
hold <Ctrl>, then use the navigation
( , , , and ) keys to move to the next desired element. As long as <Ctrl>
is held down, the block moved away from is not highlighted. If the block is
highlighted, it will be unhightlighted.
b.
Release <Ctrl>, but do not press any navigation keys.
4.
To highlight another element or group of elements, repeat steps 2 and 3
as required.
5.
To cut or copy, press <Ctrl+X> or <Ctrl+C>.
6.
To save a preset, press <Alt+T>, then right arrow , then down arrow , then
press <Enter> (see figure 62).
7.
The Save a Preset dialog box appears.
a.
<Tab> to the preset number field and type a specific preset number.
b.
<Tab> to the preset name field and type a preset name.
notE: Unless entering a specific number and name, DSP Configurator
enters the next sequential unused preset number.
c.
<Tab> to highlight OK and press <Enter>.
Alt
T
Enter
Figure 62.
Saving a Preset Using Keyboard Navigation
DMP 128 • Software Control
99