Extron Electronics DMS 1600_2000_3200_3600 User Guide - Manual (Page 111)

DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Maintenance and Modifications 105
3. Gently pull on the screws to loosen the fan from the backplane.
4. Slide the fan out of the chassis.
Installing a Fan Module
1. Orient the fan to be installed so that the printing on the back of the panel is right-side up.
2. Align the flanges on the fan with the top and bottom plastic chassis guides
(see
figure 70 , on the previous page).
3. Gently slide the fan into the enclosure until the fan meets resistance.
4. Gently seat the fan in the backplane.
5. Use a screwdriver to tighten the top and bottom screws to lock the fan in place.
6. Secure the row identification plate to the fan.