Extron Electronics DMS 1600_2000_3200_3600 User Guide User Manual

Page 16

Advertising
background image

DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Installation

10

Below are installation guidelines for the switcher configuration; if you incorrectly order the
I/O boards, the switcher will not recognize some inputs, outputs, or both.

•

You

must install a 4x4 DVI or fiber optic input and output board in the top slot (slot 1).

•

You can install any of the six board types (a 4x4 DVI or fiber optic input and output
board, a 4 DVI or fiber optic input board, or a 4 DVI or fiber optic output board) or a
blank panel in the next slot (slot 2).

•

You can install any of the board types in the slot directly underneath a 4x4 input and
output board.

•

After you install a 4-input board or 4-output board, all active boards underneath it

must

be the same size (4-input or 4-output).

•

Within these size guidelines (4-input must follow 4-input or 4-output must follow
4-output), you can follow a DVI board with a fiber optic board or follow a fiber optic
board with a DVI board.

•

If you install a blank panel, all slots under it

must contain blank panels (you cannot skip

a slot).

I/O connections

WARNING: Risk of serious physical injury — The DMS fiber optic I/O boards output

continuous invisible light, which may be harmful to the eyes; use with caution. For
additional safety, plug the attached dust caps into the optical transceivers when the
fiber cable is unplugged.

NOTES:

•

Fiber optic boards: Ensure that you use multimode fiber cable for your I/O board.
Typically, multimode cable has an orange or aqua jacket.

•

DVI boards: Although the DVI I/O boards use DVI-I connectors, the switchers
handle only DVI-D (digital) video and the boards are labeled “DVI-D.”

a

DVI-D Inputs ports — Connect DVI cables between these ports and the DVI output

ports of the digital video sources (see figure 8).

b

DVI-D Outputs ports — Connect DVI displays for the routed direct digital image

(see figure 8).

Pin

Signal

1

TMDS data 2–

TMDS data 2+

TMDS data 1–

TMDS data 1+

DDC clock

+5 V power

DDC data

TMDS clock+

Ground (+5 V)

CEC control*

TMDS clock–

Hot Plug Detect

TMDS data 0–

TMDS data 0+

Spare
Spare

Spare
Spare

Spare
Spare

TMDS data 2

shield

TMDS data 1

shield

TMDS data 0

shield

TMDS clock

Shield

Pin

Pin

Signal

Signal

2

9

10

17

4

12

20

5

13

21

6

14

22

7

15

23

8

* CEC control on pin 8
is a proprietary usage,
not the industry
standard.

16

24

18

3

11

19

1

9

8

17

24

Female Connector

Male Connector

Figure 8.

DVI Connectors

Advertising